Bear paw copper and turquoise charm necklace

8D This is my bear spirit copper and turquoise necklace. I have a wolf one I am putting up soon too XD

So, a little about how I make these. First you cover the area you want raised, in ink. I do the entire back, the edges and inside the hole part and of course the image, then you leave it in special etching acid for about one hour and thirty minutes to two hours depending. when I am done, I take it out using a wire I attached before hand, and run to the sink 8D Water neutralizes the acid, so you have to leave it under running water for a while. As this is going on, I start rubbing the ink off gently and if its stubborn, I use an S.O.S pad on it XD Buff it up real nice so its shiny XD So each one of these takes about 3-4 hours to complete, not including the necklace making part but than can be done while its sitting in the acid.

Anyways, its for sale a long with others on my Etsy page:
[link]